Dell Force10 S4810P FTOS Command Line Reference Guide for the S4810 System FTO - Page 127

• For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For Loopback interfaces, enter the keyword loopback followed by a number from zero (0) to 16383. • For the SONET interfaces, enter the keyword sonet followed by slot/port information. • For a Port Channel, enter the keyword port-channel followed by a number. For the C-Series and S-Series, 1 to 128. For the E-Series, 1 to 32 for EtherScale, 1 to 255 for TeraScale, and 1 to 512 for ExaScale. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE followed by the slot/port information. • For VLAN interface, enter the keyword vlan followed by a number from 1 to 4094. Defaults Command Modes Command History Related Commands The IP address on the system that is closest to the Telnet address is used in the outgoing packets. CONFIGURATION Version 8.3.11.1 Version 8.5.1.0 Version 8.2.1.0 Version 8.1.1.0 Version 7.6.1.0 Version 7.5.1.0 E-Series Introduced on the Z9000. Added support for 4-port 40G line cards on ExaScale. Increased number of VLANs on ExaScale to 4094 (was 2094). Introduced on the E-Series ExaScale. Introduced on the S-Series. Introduced on the C-Series. Original command telnet - telnets to another device. ip tftp source-interface Assign an interface's IP address in outgoing packets for TFTP traffic. C-Series, E-Series, S-Series, Z-Series Syntax ip tftp source-interface interface To return to the default setting, use the no ip tftp source-interface interface command. 127