Dell Force10 S4810P FTOS Command Line Reference Guide for the S4810 System FTO - Page 775

interface range macro name Run the interface-range macro to automatically configure the pre-defined range of interfaces. C-Series, E-Series, S-Series, Z-Series Syntax Parameters interface range macro name name Enter the name of an existing macro. Defaults Command Modes Command History none CONFIGURATION Version 8.3.11.1 Version 8.1.1.0 Version 7.6.1.0 Version 7.5.1.0 Version 6.2.1.0 Introduced on the Z9000. Introduced on the E-Series ExaScale. Introduced on the S-Series. Introduced on the C-Series. Introduced Example (Single Range) This example shows the macro named test that was defined earlier. FTOS(config)#interface range macro test FTOS(config-if-range-te-0/0-3,gi-5/0-47,gi-13/0-89)# FTOS Related Commands interface range - configures a range of command (bulk configuration). interface range macro (define) - defines a macro for an interface range (bulk configuration). interface vlan Configure a VLAN. You can configure up to 4096 VLANs. Z-Series, S4810, and MXL Switch Syntax Parameters interface vlan vlan-id [of-instance{of-id}] vlan-id of-instance{of-id} Enter a number as the VLAN Identifier. The range is 1 to 4096. Enter the keyword of-instance followed by the OpenFlow instance ID to add the VLAN to the specified OpenFlow instance. Range is 1 to 8. NOTE: You must associate the OpenFlow instance with the VLAN when the VLAN is created. An existing VLAN cannot be associated with an OpenFlow instance. Defaults Command Modes Not configured, except for the Default VLAN, which is configured as VLAN 1. CONFIGURATION 775