Dell Inspiron 14 5410 Inspiron 14 5418 Service Manual - Page 42
Installing the I/O board, Prerequisites, About this task, Steps, Next steps
View all Dell Inspiron 14 5410 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
Installing the I/O board Prerequisites If you are replacing a component, remove the existing component before performing the installation process. About this task The following image(s) indicate the location of the I/O board and provides a visual representation of the installation procedure. Steps 1. Align the ports on the I/O board to the slots on the palm-rest and keyboard assembly. 2. Place the I/O board on the palm-rest and keyboard assembly. 3. Align the screw hole on the I/O board to the screw hole on the palm-rest and keyboard assembly. 4. Replace the screw (M2x3) that secures the I/O board to the palm-rest and keyboard assembly. 5. Close the left-display hinge and align the screw holes on the left-display hinge with the screw holes on the I/O board. 6. Replace the two screws (M2.5x4) that secure the left-display hinge to the I/O board. 7. Connect the I/O-board cable to the connector on the I/O board and close the latch. 8. Connect the power-button with fingerprint-reader cable to the connector on the I/O board and close the latch. NOTE: This step is only applicable for computers shipped with the optional fingerprint reader. 9. Connect the coin-cell battery cable to the I/O board. Next steps 1. Install the base cover. 2. Exit Service Mode. 3. Follow the procedure in After working inside your computer. 42 Removing and installing components