Dell Inspiron 23 All-in-One Owners Manual - Page 70
Clearing Forgotten Passwords, Clearing CMOS Settings, Discard Changes and Reset
View all Dell Inspiron 23 All-in-One manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 70 highlights
Exit Save Changes and Reset Discard Changes and Reset Load Defaults Allows you to exit system setup and save your changes Allows you to exit system setup and load previous values for all system setup options Allows you to load default values for all system setup options Clearing Forgotten Passwords WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the steps in "Before You Begin" on page 9. After working inside your computer, follow the instructions in "After Working Inside Your Computer" on page 11. For more safety best practices information, see the Regulatory Compliance Homepage at dell.com/regulatory_compliance. 1 Remove the base cover. See "Removing the Base Cover" on page 15. 2 Disconnect the USB-board cable from the system board. See "Removing the System Board" on page 40. 3 Replace the base cover. See "Replacing the Base Cover" on page 17. 4 Turn on the computer to clear all BIOS passwords. 5 Remove the base cover. See "Removing the Base Cover" on page 15. 6 Connect the USB-board cable to the system board. See "Replacing the System Board" on page 42. 7 Replace the base cover. See "Replacing the Base Cover" on page 17. Clearing CMOS Settings WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the steps in "Before You Begin" on page 9. After working inside your computer, follow the instructions in "After Working Inside Your Computer" on page 11. For more safety best practices information, see the Regulatory Compliance Homepage at dell.com/regulatory_compliance. 1 Remove the base cover. See "Removing the Base Cover" on page 15. 2 Disconnect the coin-cell battery cable from the system board. 3 Wait for approximately five seconds to clear the CMOS settings. 4 Connect the coin-cell battery cable to the system board. 5 Replace the base cover. See "Replacing the Base Cover" on page 17. 70 | System Setup