Dell Inspiron 531 Owner's Manual - Page 134
see Removing the FlexBay Break-Away Metal Plate
View all Dell Inspiron 531 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 134 highlights
4 Disconnect the FlexBay USB cable and the power cable from the back of the Media Card Reader and from the internal USB connector on the system board (see "System Board Components" on page 102). 5 Remove the two screws securing the Media Card Reader. 6 Slide the Media Card Reader out through the front of the computer. 7 If you are not reinstalling the Media Card Reader, replace the drive panel insert (see "Replacing the Drive Panel Insert" on page 132). 8 Replace the bezel (see "Replacing the Bezel" on page 119). 9 Replace the computer cover (see "Replacing the Computer Cover" on page 164. 10 Connect your computer and devices to electrical outlets, and then turn them on. Installing a Media Card Reader 1 Follow the procedures in "Before You Begin" on page 97. 2 Remove the computer cover (see "Removing the Computer Cover" on page 99). 3 Remove the bezel (see "Removing the Bezel" on page 118). 4 If you are installing a new Media Card Reader rather than replacing a Media Card Reader, remove the break-away metal plate from the FlexBay (see "Removing the FlexBay Break-Away Metal Plate" on page 131). 5 Remove the Media Card Reader from its packaging. 6 Gently slide the Media Card Reader into place in the FlexBay slot. 7 Align the screw slots in the Media Card Reader with the screw slots in the FlexBay. 8 Tighten the two screws to secure the Media Card Reader. NOTE: Ensure that the Media Card Reader is installed before the FlexBay cable is connected. 9 Connect the FlexBay USB cable to the back of the Media Card Reader and to the internal USB connector on the system board (see "System Board Components" on page 102). 134 Removing and Installing Parts