Dell Latitude 2100 Dell™ Mobile Computing Station - Page 4

Set-Up and Go - battery

Page 4 highlights

Set-Up and Go CAUTION: Observe all safety precautions related to Mobile Computing Station operation and maintenance included in this reference guide! 1 Attach left and right handles and caps Eight screws (four at each handle) and a hex tool have been provided. ENGLISH 2 Netbook Docking Open top compartments: unlock door, lift door up and out (to clear holding tab), allow door to drop slightly, then lift up and push under work top. Insert netbooks into docks with front edge of netbook at top and power /Ethernet connectors leading into station. The green tab at the front of the dock will be visible if the netbook has been properly seated. Charging activity can be viewed at the top edge of each netbook when docked. Netbook charge indicator Green tab location CAUTION: Make sure area is clear before closing upper door. CAUTION: There is no on/off switch on this equipment; the AC power cord is the only power disconnect. The socket outlet should be easily accessible and should be installed near the equipment. 3 First Time Battery Charge Before using the netbooks for the first time or after spending time in storage, ensure netbooks have a full (100%) charge. Connect power cord to a dedicated circuit, (one not shared with other devices). Verify that the blue light on the Power/Fault Status Indicator at the work-top is lit. Allow netbooks to charge for at least 2-3 hours before removing for first-time use. Monitoring Netbook Power The Power/Fault Status Indicator lights at the top of the Mobile Computing Station communicate the following conditions. Power/Fault Status Indicator Signal Meaning Blue light - Solid Power "ON" Amber light - Flashing Maximum temperature has been exceeded * When recommended temperature has been exceeded, power to Netbooks is terminated until the temperature falls into an acceptable operating range, at which time charging resumes. NOTE: Charge status of individual netbooks can be seen directly on netbooks when docked and the upper compartment doors are open. 4 of 16 888-24-078-W-06 rev.G • 08/09

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16

4 of 16
888-24-078-W-06 rev.G • 08/09
ENGLISH
Set-Up and Go
1
Attach left and right handles and caps
2
Netbook Docking
3
First Time Battery Charge
Monitoring Netbook Power
Open top compartments: unlock door, lift door up and
out (to clear holding tab), allow door to drop slightly,
then lift up and push under work top.
Insert netbooks into docks with front edge of netbook at
top and power /Ethernet connectors leading into station.
The green tab at the front of the dock will be visible if the
netbook has been properly seated.
Charging activity can be viewed at the top edge of each
netbook when docked.
CAUTION:
Make sure area is clear before closing
upper door.
Eight screws (four at each handle) and a hex tool have been provided.
Before using the netbooks for the first time or after spending time in
storage, ensure netbooks have a full (100%) charge.
Connect power cord to a dedicated circuit, (one not shared with
other devices).
Verify that the blue light on the Power/Fault Status Indicator at the
work-top is lit.
Allow netbooks to charge for at least 2-3 hours before removing
for first-time use.
T
he Power/Fault Status Indicator lights at the top of the Mobile Computing Station communicate the following conditions.
NOTE:
Charge status of individual netbooks can be seen directly on netbooks when docked and the upper compartment doors are open.
CAUTION:
Observe all safety precautions related to
Mobile Computing Station operation and maintenance
included in this reference guide!
Blue light - Solid
Power "ON"
Amber light - Flashing
Maximum temperature has been exceeded
* When recommended temperature has been exceeded, power to Netbooks is
terminated until the temperature falls into an acceptable operating range, at which
time charging resumes.
CAUTION:
There is no on/off
switch on this equipment; the AC power cord is the only power disconnect. The
socket outlet should be easily accessible and should be installed near the equipment.
Green tab
location
Netbook charge
indicator
Power/Fault Status Indicator
Signal
Meaning