Dell Latitude E5400 Service Manual - Page 42
Memory - user manual
View all Dell Latitude E5400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
Back to Contents Page Memory Dell™ Latitude™ E5400 and E5500 Service Manual Removing a Memory Module Replacing a Memory Module Your computer has two user-accessible SODIMM sockets, both accessed from the bottom of the computer. You can increase your computer memory by installing memory modules on the system board. See "Specifications" in your Setup and Quick Reference Guide for information on the memory supported by your computer. Install only memory modules that are intended for your computer. NOTE: Memory modules purchased from Dell are covered under your computer warranty. Removing a Memory Module CAUTION: Before you begin any of the procedures in this section, follow the safety instructions that shipped with your computer. For additional safety best practices information, see the Regulatory Compliance Homepage on www.dell.com at: www.dell.com/regulatory_compliance. 1. Follow the procedures in Before Working on Your Computer. 2. Close the display and turn the computer upside down. 3. Remove the bottom of the base assembly (see Removing the E5400 Bottom of the Base Assembly or Replacing the E5400 Bottom of the Base Assembly). NOTICE: To prevent damage to the memory module connector, do not use tools to spread the memory module securing clips. 4. Use your fingertips to carefully spread apart the securing clips on each end of the memory module connector until the memory module pops up. 5. Remove the memory module from the connector. 1 tab 3 E5400 2 notch 1 tab 3 E5500 2 notch