Dell MX9116n OS10 Enterprise Edition User Guide for PowerEdge MX IO Modules Re - Page 92
Minimum links, Assign Port Channel IP Address, Remove or disable port-channel
View all Dell MX9116n manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 92 highlights
LACP enables ports to be dynamically bundled as members of a port-channel. To configure a port for LACP operation, use the channelgroup mode command. Active and passive modes allow LACP to negotiate between ports to determine if they can form a port -channel based on their configuration settings. OS10(config)# interface port-channel 100 OS10(conf-if-po-10)# exit OS10(config)# interface ethernet 1/1/2 OS10(conf-if-eth1/1/2)# channel-group 100 mode active Minimum links Configure minimum links in a port-channel (LAG) that must be in oper up status to consider the port-channel to be in oper up status. • Enter the number of links in a LAG that must be in oper up status in PORT-CHANNEL mode (1 to 32, default 1). minimum-links number Configure minimum operationally up links OS10(config)# interface po 1 OS10(conf-if-po-1)# minimum-links 5 Assign Port Channel IP Address You can assign an IP address to a port channel and use port channels in L3 routing protocols. • Configure an IP address and mask on the interface in INTERFACE PORT-CHANNEL mode. ip address ip-address mask [secondary-ip-address] - ip-address mask - Specify an IP address in dotted-decimal format (A.B.C.D) and the mask in slash format. - secondary-ip-address - Specify a secondary IP address in dotted-decimal format (A.B.C.D), which will act as the interface's backup IP address. Assign Port Channel IP Address OS10# configure terminal OS10(config)# interface port-channel 1 OS10(conf-if-po-1)# ip address 1.1.1.1/24 OS10(conf-if-po-1)# Remove or disable port-channel You can delete or disable a port-channel. 1 Delete a port-channel in CONFIGURATION mode. no interface port-channel channel-number 2 Disable a port-channel to place all interfaces within the port-channel operationally down in CONFIGURATION mode. shutdown Delete port-channel OS10(config)# interface port-channel 10 OS10(conf-if-po-10)# no interface port-channel 10 92 Interfaces