Dell OptiPlex 7000 Small Form Factor Service Manual - Page 72
Install the, Follow the procedure
![]() |
View all Dell OptiPlex 7000 Small Form Factor manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 72 highlights
Steps 1. Place and align the screw holes on the power-supply unit to the screw holes on the chassis. 2. Replace the three (M6-32) screws to secure the power-supply unit to the chassis. 3. Route the power-supply cables through the routing guides on the chassis. 4. Connect the power-supply cables to the connectors on the system board. Next steps 1. Install the disk-drive cage. 2. Install the 3.5-inch hard-drive. 3. Install the 2.5-inch hard-drive. 4. Install the front bezel. 5. Install the side cover. 6. Follow the procedure in after working inside your computer. 72 Removing and installing components
![](/manual_guide/products/dell-optiplex-7000-small-form-factor-service-manual-a48ccd3/72.png)
Steps
1.
Place and align the screw holes on the power-supply unit to the screw holes on the chassis.
2.
Replace the three (M6-32) screws to secure the power-supply unit to the chassis.
3.
Route the power-supply cables through the routing guides on the chassis.
4.
Connect the power-supply cables to the connectors on the system board.
Next steps
1.
Install the
disk-drive cage
.
2.
Install the
3.5-inch hard-drive
.
3.
Install the
2.5-inch hard-drive
.
4.
Install the
front bezel
.
5.
Install the
side cover
.
6.
Follow the procedure in
after working inside your computer
.
72
Removing and installing components