Dell OptiPlex 7020 Small Form Factor Owners Manual - Page 50
Error Message, hard-disk drive
View all Dell OptiPlex 7020 Small Form Factor manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 50 highlights
Error Message Description Memory allocation The software you are attempting to run is conflicting with the operating system, error another program, or a utility. Memory data line failure at address, read value expecting value A memory module may be faulty or improperly seated. Reinstall the memory modules and, if necessary, replace them. Memory double word logic failure at address, read value expecting value A memory module may be faulty or improperly seated. Reinstall the memory modules and, if necessary, replace them. Memory odd/even A memory module may be faulty or improperly seated. Reinstall the memory logic failure at modules and, if necessary, replace them address, read value expecting value Memory write/read A memory module may be faulty or improperly seated. Reinstall the memory failure at address, modules and, if necessary, replace them. read value expecting value Memory size in CMOS invalid The amount of memory recorded in the computer configuration information does not match the memory installed in the computer. Memory tests terminated by keystroke A keystroke interrupted the memory test. No boot device available The computer cannot find the floppy disk or hard drive. No boot sector on The computer configuration information in System Setup may be incorrect. hard-disk drive No timer tick interrupt A chip on the system board might be malfunctioning. Non-system disk or disk error The floppy disk in drive A does not have a bootable operating system installed on it. Either replace the floppy disk with one that has a bootable operating system, or remove the floppy disk from drive A and restart the computer. Not a boot diskette The operating system is trying to boot to a floppy disk that does not have a bootable operating system installed on it. Insert a bootable floppy disk. Plug and play The computer encountered a problem while trying to configure one or more cards. configuration error Read fault The operating system cannot read from the floppy or hard drive, the computer could not find a particular sector on the disk, or the requested sector is defective. Requested sector The operating system cannot read from the floppy or hard drive, the computer not found could not find a particular sector on the disk, or the requested sector is defective. 50