Dell OptiPlex 7080 Tower Setup and specifications guide - Page 28
Security, Table 24. Video, Table 25. Security
View all Dell OptiPlex 7080 Tower manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
Table 24. Video Option Security Table 25. Security Option Admin Password System Password Internal HDD-0 Password Password Configuration Password Bypass Password Change UEFI Capsule Firmware Updates TPM 2.0 Security Absolute Description ● Auto (default) ● Intel HD Graphics NOTE: If you do not select Auto, the on-board graphics device will be present and enabled. Description Allows you to set, change, and delete the admin password. Allows you to set, change, and delete the system password. Allows you to set, change, and delete the computer's internal hard drive password. Allows you to control the minimum and maximum number of characters that are allowed for an administrative password and the system password. The range of characters is between 4 and 32. This option lets you bypass the System (Boot) Password and the internal hard drive password prompts during a system restart. ● Disabled - Always prompt for the system and internal HDD password when they are set. This option is disabled by default. ● Reboot Bypass - Bypass the password prompts on Restarts (warm boots). NOTE: The system will always prompt for the system and internal HDD passwords when powered on from the off state (a cold boot). Also, the system will always prompt for passwords on any module bay HDDs that may be present. This option lets you determine whether changes to the System and Hard Disk passwords are permitted when an administrator password is set. Allow Non-Admin Password Changes - This option is enabled by default. This option controls whether this system allows BIOS updates via UEFI capsule update packages. This option is selected by default. Disabling this option will block BIOS updates from services such as Microsoft Windows Update and Linux Vendor Firmware Service (LVFS). Allows you to control whether the Trusted Platform Module (TPM) is visible to the operating system. ● TPM On (default) ● Clear ● PPI Bypass for Enable Commands ● PPI Bypass for Disable Commands ● PPI Bypass for Clear Commands ● Attestation Enable (default) ● Key Storage Enable (default) ● SHA-256 (default) Choose any one option: ● Disabled ● Enabled (default) This field lets you Enable, Disable or permanently Disable the BIOS module interface of the optional Absolute Persistence Module service from Absolute Software. ● Enabled - This option is selected by default. ● Disable 28 System setup