Dell PowerConnect 8100 Getting Started Guide - Page 25

Example Session This section describes an Easy Setup Wizard session. The following values are used by the example session: NOTE: There is no username, password, or ip address when the switch is unboxed or set to factory defaults. • SNMP is not enabled. • The default user name, root, is accepted and a password of admin123 is entered. The Wizard does not display the password as it is entered. • The OOB management interface uses 192.168.2.1 for IP address assignment. NOTE: In the example below, the possible user options or default values are enclosed in [ ]. If you press with no options defined, the default value is accepted. Help text is in parentheses. The following example contains the sequence of prompts and responses associated with running an example Dell Easy Setup Wizard session, using the input values listed above. After the switch completes the POST and is booted, the following text is displayed: (Unit 1-Waiting to select management unit)> Applying Global configuration, please wait ... Welcome to Dell Easy Setup Wizard The Setup Wizard guides you through the initial switch configuration, and gets you up and running as quickly as possible. You can skip the setup wizard, and enter CLI mode to manually configure the switch. You must respond to the next question to run the setup wizard within 60 seconds, otherwise the system will continue with normal operation using the default system configuration. Note: You can exit the setup wizard at any point by entering [ctrl+z]. Would you like to run the setup wizard (you must answer this question within 60 seconds)? [Y/N] y Starting and Configuring the Switch 23