Dell PowerConnect B-RX4 BigIron RX Configuration Guide (Supporting Multi-Servi - Page 531

Displaying VRRP and VRRPE information 17 TABLE 86 CLI display of VRRP or VRRPE detailed information (Continued) This field... Displays... mode virtual MAC priority current priority track priority hello-interval backup hello-interval advertise backup dead-interval current dead-interval Indicates whether the device is the Owner or a Backup for the virtual router. NOTE: If "incomplete" appears after the mode, configuration for this virtual router is incomplete. For example, you might not have configured the virtual IP address that is being backup up by the virtual router. This field applies only to VRRP. All device devices configured for VRRPE are Backups. The virtual IP MAC address that this virtual router is backing up. The device's preferability for becoming the Master for the virtual router. During negotiation, the router with the highest priority becomes the Master. If two or more devices are tied with the highest priority, the Backup interface with the highest IP address becomes the active router for the virtual router. The current VRRP or VRRPE priority of this device for the virtual router. The current priority can differ from the configured priority (see the row above) for the following reasons: • The virtual router is still in the initialization stage and has not become a Master or Backup yet. In this case, the current priority is 0. • The virtual router is configured with track ports and the link on a tracked interface has gone down. Refer to "Track ports and track priority" on page 442. VRRPE priority value assigned to the tracked port. The number of seconds between Hello messages from the Master to the Backups for a given virtual router. The number of seconds between Hello messages from a Backup to the Master. The IP addresses of Backups that have advertised themselves to this device by sending Hello messages. NOTE: Hello messages from Backups are disabled by default. You must enable the Hello messages on the Backup for the Backup to advertise itself to the current Master. Refer to "Hello interval" on page 452. The configured value for the dead interval. The dead interval is the number of seconds a Backup waits for a Hello message from the Master for the virtual router before determining that the Master is no longer active. If the Master does not send a Hello message before the dead interval expires, the Backups negotiate (compare priorities) to select a new Master for the virtual router. NOTE: If the value is 0, then you have not configured this parameter. NOTE: This field does not apply to VRRP Owners. The current value of the dead interval. This is the value actually in use by this interface for the virtual router. NOTE: This field does not apply to VRRP Owners. BigIron RX Series Configuration Guide 459 53-1001810-01