Dell PowerConnect Brocade 815 Brocade Adapters Troubleshooting Guide - Page 120
Echo test, Performing an echo test through BCU
View all Dell PowerConnect Brocade 815 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 120 highlights
3 Diagnostics 6. Enter a test cycle if desired. 7. Click Start. Echo test Use the BCU and HCM to initiate an echo test between the adapter port and a Fibre Channel end point. This sends an ECHO command and response sequence between the adapter port and target port to verify connection with the target. Performing an echo test through BCU Use the fcdiag --fcecho BCU command to initiate an echo test between the adapter and remote port. fcdiag --fcecho [-l ] where: port_id rpwwn lpwwn ID of the port that you want to test. This could be the PWWN, port hardware path, or user-specified port name. This could also be the adapter-index/port-index. For example, to specify adapter 1, port 1 you would use 1/1 as the port identification. Remote port WWN to which the echo command is being sent. Logical port WWN. 0 indicates the base port. Performing an echo test through HCM Use the Echo Test feature as follows to initiate an echo test between the adapter port and a Fibre Channel end point. 1. Launch the HCM. 2. Select Configure > Diagnostics to display the Diagnostics dialog box. 3. Click the FC Protocol Tests tab. 4. Select Echo Test. 5. Select the adapter port and target port for the test. 6. Enter a test cycle if applicable. 7. Click Start. 96 Brocade Adapters Troubleshooting Guide 53-1002145-01