Dell PowerConnect Brocade M5424 Brocade 7.1.0 Fabric OS Message Reference Guid - Page 314

5 EM-1061 EM-1061 Message Synchronization halted. Remove all blades of type or upgrade your standby CP, then reboot or run haSyncStart. Message Type LOG Severity WARNING Probable Cause Indicates that the blade in the system is not supported by the firmware on the standby control processor (CP). Recommended Action Remove all blades of the specified type or upgrade the standby CP. After an appropriate action is taken, restart the standby CP or execute the haSyncStart command to enable the high availability (HA) state synchronization. Until this is done, the system will remain out of synchronization. EM-1062 Message Blade in slot faulted as it exceeds the maximum support limit of blades with Blade ID in the chassis. Message Type LOG Severity CRITICAL Probable Cause Indicates that too many blades of a particular type are in the system. Recommended Action Remove the faulted blade. EM-1063 Message Blade in slot faulted because it exceeds the maximum support limit of blades with Blade IDs in the chassis. Message Type LOG Severity CRITICAL Probable Cause Indicates that too many blades of a set of particular types are in the system. Recommended Action Remove the faulted blade. 292 Fabric OS Message Reference 53-1002749-01