Dell PowerConnect Brocade M6505 Brocade 7.1.0 Fabric OS Troubleshooting and Di - Page 112
Con Port 1 on Switch A as a D_Port, by using, Enable Port 2 on Switch B using
View all Dell PowerConnect Brocade M6505 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 112 highlights
10 Diagnostic Port (D_Port) 1. Disable Port 1 on Switch A, by using the portDisable [slot/]port command. switchA:admin> portdisable 1 2. Configure Port 1 on Switch A as a D_Port, by using portCfgDport - -enable [slot/]port. switchA:admin> portcfgdport --enable 1 3. Repeat steps 1 and 2 for the corresponding port (in this example Port 2) on Switch B. switchB:admin> portdisable 2 switchB:admin> portcfgdport --enable 2 4. Enable Port 1 on Switch A by using the portEnable [slot/]port command. switchA:admin> portenable 1 5. Enable Port 2 on Switch B using the portEnable [slot/]port command. switchB:admin> portenable 2 NOTE The basic test suite starts as soon as both ports are enabled. The order in which they are enabled does not matter. 6. While the test is running, enter the portDportTest [slot/]port - -show command to view test results. The following test is successful. switch:admin> portdporttest --show 10/39 D-Port Information: Slot: 10 Port: 39 Remote WWNN: 10:00:00:05:33:7e:69:c4 Remote port: 24 Mode: Manual No. of test frames: 12 Million Test frame size: 1024 Bytes Payload Pattern: JTSPAT FEC (enabled/option/active): Yes/No/No CR (enabled/option/active): No/No/No Start time: Mon Jan 16 05:57:51 2012 End time: Mon Jan 16 05:58:56 2012 Status: PASSED Test Start time Result EST(HH:MM:SS) Comments === Electrical loopback 05:57:52 PASSED --------- ---------- Optical loopback 05:58:06 PASSED -------- ---------- Link traffic test 05:58:13 PASSED -------- ---------- Roundtrip link latency: 934 nano-seconds Estimated cable distance: 1 meters Buffers required: 1 (for 1024 byte frames at 16Gbps speed) 96 Fabric OS Troubleshooting and Diagnostics Guide 53-1002751-01