Dell PowerConnect Brocade M6505 Brocade 7.1.0 Fabric OS Troubleshooting and Di - Page 46
Correcting a port that has come up in the wrong mode, Marginal links
View all Dell PowerConnect Brocade M6505 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
3 Marginal links After becoming an active port, the port becomes an F_Port or an E_Port depending on the device on the opposite side. If the opposite device is a host or target device, the port becomes an F_Port. If the opposite device is another switch, the port becomes an E_Port. If there is a problem with the host or target device, enter portCfgGPort to force the port to try to come up as point-to-point only. Correcting a port that has come up in the wrong mode 1. Enter the switchShow command. 2. Check the output from the switchShow command and follow the suggested actions in Table 4. TABLE 4 SwitchShow output and suggested action Output Suggested action Disabled Bypassed Loopback E_Port F_Port G_Port L_Port If the port is disabled because persistent disable or security reasons, attempt to resolve the issue and then enter the portEnable or, if persistently disabled, portCfgPersistentEnable command. The port may be testing. The port may be testing. If the opposite side is not another switch, the link has come up in a wrong mode. Check the output from the portLogShow or PortLogDump commands and identify the link initialization stage where the initialization procedure went wrong. If the opposite side of the link is a private loop device or a switch, the link has come up in a wrong mode. Check the output from portLogShow or PortLogDump commands. The port has not come up as an E_Port or F_Port. Check the output from portLogShow or PortLogDump commands and identify the link initialization stage where the initialization procedure went wrong. If the opposite side is not a loop device, the link has come up in a wrong mode. Check the output from portLogShow or PortLogDump commands and identify the link initialization stage where the initialization procedure went wrong. NOTE If you are unable to read a portlog dump, contact your switch support provider for assistance. Marginal links A marginal link involves the connection between the switch and the edge device. Isolating the exact cause of a marginal link involves analyzing and testing many of the components that make up the link (including the switch port, switch SFP, cable, edge device, and edge device SFP). Troubleshooting a marginal link can involve inspecting the error counters described in "Troubleshooting a marginal link," or running diagnostics on a link, a port, or an end-to-end path. The portLoopbackTest command is used to verify the functional operation of a path on a switch. This test sends frames from a given port's transmitter and loops them back into the same port's receiver. The loopback is done at the parallel loopback path. The path traversed in this test does not include the media or the fiber cable. 30 Fabric OS Troubleshooting and Diagnostics Guide 53-1002751-01