Dell PowerConnect J-8208 Release Notes JUNOS version 10.2 - Page 11
J-Web Interface, in the Link Aggregation Configuration PR/437410]
View all Dell PowerConnect J-8208 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Outstanding Issues in JUNOS Release 10.2 for J-EX Series Switches [PR/522513] • On J-EX8200 switches, when a firewall filter is applied on the loopback (lo0) interface, the switch stops generating local ARP requests for transit traffic. As a workaround, you can do the following: • Create firewall filters to block known unwanted traffic to the Routing Engine, and then accept all other traffic. • Create firewall filters for specific hosts and all local subnets, and then discard all other traffic. [PR/486443] J-Web Interface • In the J-Web interface, you cannot commit some configuration changes in the Ports Configuration page and the VLAN Configuration page because of the following limitations for port mirroring ports and port mirroring VLANs: • A port configured as the output port for an analyzer cannot be a member of any VLAN other than the default VLAN. • A VLAN configured to receive analyzer output can be associated with only one port. [PR/400814] • In the J-Web interface, uploading a software package to the switch might not work properly if you are using Internet Explorer version 7. [PR/424859] • If an SRE module, RE module, SF module, line card, or Virtual Chassis member is in offline mode, the J-Web interface might not update the dashboard image accordingly. [PR/431441] • In the J-Web interface, in the Port Security Configuration page, you are required to configure action when you configure MAC limit even though configuring an action value is not mandatory in the CLI. [PR/434836] • In the J-Web interface, interfaces configured with no-flow-control might be displayed in the Link Aggregation Configuration page. [PR/437410] • In the J-Web interface, in the OSPF Global Settings table in the OSPF Configuration page, the Global Information table in the BGP Configuration page, or the Add Interface window in the LACP Configuration page, if you try to change the position of columns using the drag-and-drop method, only the column header moves to the new position instead of the entire column. [PR/465030] • In the J-Web interface, in the OSPF Configuration page (Configuration > Routing > OSPF), the Traceoptions tab in the Edit Global Settings window does not display the available flags (tracing parameters). As a workaround, use the CLI to view the available flags. [PR/475313] • When you have a large number of static routes configured and if you have navigated to pages other than page 1 in the Route Information table in the J-Web interface (Monitor > Routing > Route Information), changing the Route Table to query other routes refreshes the page but does not return to page 1. For example, if you run the query from page 3 and the new query returns very few results, the Results table 11