Dell PowerConnect W-IAP Remote Release Notes - Page 27
Supported full Layer 3 features
View all Dell PowerConnect W-IAP Remote manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
Supported full Layer 3 features Full Layer 3 software images include all of the management, security, system, Layer 2, base Layer 3 and edge Layer 3 features listed in the previous tables, plus the features listed in Table 10 . NOTE: Full Layer 3 features are supported in the FastIron (hardware) models listed in Table 10. These features are also supported with software-based licensing. For details, refer to the chapter "Softwarebased Licensing" in the FastIron Configuration Guide. Table 10 Supported full Layer 3 features Category and description FESX-PREM FCX FSX-PREM FSX 800-PREM FSX 1600-PREM Active host routes Yes (6,000) Yes (16,000) Anycast RP Yes No BGP4 graceful restart BGP4 Yes (FSX 800 and FSX 1600 only) Yes Distance Vector Multicast Routing Yes Protocol (DVMRP) V2 (RFC 1075) Internet Group Management Protocol (IGMP) V1, Yes V2, and V3 (for multicast routing scenarios) ICMP Redirect messages Yes Yes (ADV models in a stack) Yes (ADV models) No Yes Yes IGMP V3 fast leave (for routing) Yes Yes IPv4 point-to-point GRE IP tunnels IPv6 Layer 3 forwarding1 IPv6 over IPv4 tunnels in hardware1 Yes No (IPv6 devices only) Yes No Yes No IronWare Software Release 07.2.00a for Brocade FastIron switches Release Notes v 1.0 Page 27 of 55