Dell PowerConnect W-IAP Remote Web Management Interface User Guide - Page 143
Configuring static station
View all Dell PowerConnect W-IAP Remote manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 143 highlights
Configuring static station 4 Delete Reset Show Add Trunk Enables you to delete the added port members. To undo your changes, click Reset. Display the Trunk entries. Allows you to add new ports. Configuring static station Select Configure > Static Station to configure static station. FIGURE 109 Configuring the static station The static station display contains the following information. MAC Address Vlan ID Port QOS Type Add Modify Delete Reset Show The MAC address of the device. Enables you to select a Vlan ID. This Vlan ID field is disabled if no port was configured. The port number. The QoS attribute specifies the priority of the incoming traffic based on any value between 0 (lowest priority) and 7 (highest priority). Default is 0. Specifies the type of the device; host or route Enables you to add the MAC Address. Enables you to modify the changes. Enables you to delete the changes made. To undo your changes, click Reset. Displays the static station table entries. PowerConnect B-Series FCX Web Management Interface User Guide 133 53-1002268-01