Dell PowerEdge 2800 Information Update - Page 10

www.dell.com | support.dell.com Table 1-2. LCD Status Messages (continued) Line 1 Message E0780 E07F0 E07FA E0876 E0876 E0876 Line 2 Message Causes Corrective Actions PROC n PRESENCE Microprocessor is not installed in socket n. Install a microprocessor in socket n. See "Replacing a Processor" in your Installation and Troubleshooting Guide. PROC n IERR Faulty or improperly installed microprocessor. See "Troubleshooting the Microprocessors" in your Installation and Troubleshooting Guide. PROC n THERMTRIP Specified microprocessor is out of See "Troubleshooting System acceptable temperature range and Cooling Problems" in your has halted operation. Installation and Troubleshooting Guide. If the problem persists, ensure that the microprocessor heat sinks are properly installed. See "Replacing a Processor" in your Installation and Troubleshooting Guide. NOTE: The LCD continues to display this message until the system's power cord is disconnected and reconnected to the AC power source, or the SEL is cleared using either Server Assistant or the BMC Management Utility. See the Dell OpenManage Baseboard Management Controller User's Guide for information about these utilities. PS n MISSING PS n STATUS No power available from the specified power supply; specified power supply is improperly installed or faulty. See "Troubleshooting Redundant Power Supplies" in your Installation and Troubleshooting Guide. PS n PREDICTIVE Power supply voltage is out of See "Troubleshooting Redundant acceptable range; specified power Power Supplies" in your supply is improperly installed or Installation and Troubleshooting faulty. Guide. PS n AC LOST PS n AC RANGE Power source for specified power Check the AC power source supply is unavailable, or out of for the specified power supply. acceptable range. 8 Information Update