Dell PowerEdge 2950 Rack Installation Guide - Page 22
If you have selected the correct ramp assembly, the wireform guide will seat correctly in the catch
View all Dell PowerEdge 2950 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
2 Fit the latch of the ramp assembly on the ramp assembly bracket, located on the opposite side of the rack from where you attached the cable-management arm (see Figure 1-11). 3 To slide the cable-management arm into place: a Locate the ramp assembly wireform guide at the bend of the cable-management arm. b Lift and slide the ramp assembly wireform guide up the ramp, stopping at the ramp assembly seating catch. c If you have selected the correct ramp assembly, the wireform guide will seat correctly in the catch at the top of the ramp assembly each time the system is cycled in the rack. Figure 1-11 shows the left ramp assembly installed with the cable-management arm attached on the right. To disengage the cable-management arm ramp assembly, press the ramp assembly release button on the ramp assembly latch and pull the ramp assembly off the bracket (see Figure 1-11). Figure 1-11. 1 Installing the Cable-Management Arm Ramp Assembly 3 2 4 5 6 1 ramp assembly bracket 4 ramp assembly seating catch 2 cable-management arm ramp assembly latch 5 left cable-management arm ramp assembly 3 ramp assembly release button 6 ramp assembly wireform guide NOTE: In Figure 1-11, the cable-management arm is attached on the right side of the rack and the left cablemanagement arm ramp assembly is attached to the left side of the rack. Conversely, if you attach the cablemanagement arm on the left side of the rack, attach the right cable-management arm ramp assembly to the right side of the rack. 20 Rack Installation Guide