Dell PowerEdge 2970 Information Update - Page 17
a SAS Controller Daughter Card in your, of the optical drive. - drives
View all Dell PowerEdge 2970 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Figure 1-3. SAS/SATA Backplane Board Removal 1 2 3 1 drive carrier 3 SAS-backplane board release pin 2 SAS backplane board 4 If present, disconnect the optical drive power cable from the SAS/SATA backplane board. See Figure 1-4 for the location of the optical drive power connector. 5 Disconnect the SAS cable(s) from the backplane connectors. See Figure 1-4 for the location of the SAS cable connectors. 6 If an optical drive is installed, disconnect the data cable from the back of the optical drive. 7 If present, remove the storage controller daughter card. See "Removing a SAS Controller Daughter Card" in your Hardware Owner's Manual. Information Update 17
Information Update
17
Figure 1-3.
SAS/SATA Backplane Board Removal
4
If present, disconnect the optical drive power cable from the SAS/SATA
backplane board. See Figure 1-4 for the location of the optical drive power
connector.
5
Disconnect the SAS cable(s) from the backplane connectors.
See Figure 1-4 for the location of the SAS cable connectors.
6
If an optical drive is installed, disconnect the data cable from the back
of the optical drive.
7
If present, remove the storage controller daughter card. See "Removing
a SAS Controller Daughter Card" in your
Hardware Owner’s Manual
.
1
drive carrier
2
SAS backplane board
3
SAS-backplane board release pin
3
1
2