Dell PowerEdge C1100 Hardware Owner's Manual - Page 56
Heat Sinks, Removing the Heat Sink
View all Dell PowerEdge C1100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 56 highlights
Heat Sinks CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product. Removing the Heat Sink 1 Turn off the system, including any attached peripherals, and disconnect the system from its electrical outlet. 2 Open the system. See "Opening the System" on page 53. 3 Remove the cooling shroud. See "Removing the Cooling Shroud" on page 54. 4 Remove the expansion-card riser if applicable. See "Removing the Expansion-Card Riser" on page 66. WARNING: The heat sink is hot to touch for some time after the system has been powered down. Allow the heat sink to cool before handling it. CAUTION: Never remove the heat sink from a processor unless you intend to remove the processor. The heat sink is necessary to maintain proper thermal conditions. 5 Using a #2 Phillips screwdriver, loosen one of the heat-sink retention screws. See Figure 3-7. Wait 30 seconds for the heat sink to loosen from the processor. 6 Remove the other three heat-sink retention screws. 7 Gently lift the heat sink off of the processor and set the heat sink aside with thermal grease side facing up. 56 Installing System Components