Dell PowerEdge M1000e Access Gateway Administrator’s Guide - Page 89
Troubleshooting, TABLE 10 - solution
View all Dell PowerEdge M1000e manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 89 highlights
Troubleshooting Appendix A This appendix provides troubleshooting instructions. TABLE 10 Problem Troubleshooting Cause Solution Switch is not in Access Gateway mode NPIV disabled on Edge switch ports Need to reconfigure N_Port and F_Ports LUNs are not visible Switch is in Native switch mode Disable switch using the switchDisable command. Enable Access Gateway mode using the ag --modeenable command. Answer yes when prompted; the switch reboots. Log in to the switch. Display the switch settings using the switchShow command. Verify that the field switchMode displays Access Gateway mode. Inadvertently turned off On the Edge switch, enter the portCfgShow command. Verify that NPIV status for the port to which Access Gateway is connected is ON. If the status displays as "--" NPIV is disabled. Enter the portCfgNpivPort port_number command with the enable operand to enable NPIV. Repeat this step for each port as required. Default port setting not adequate for customer environment Enter the portCfgShow command. For each port that is to be activated as an N_Port, enter the portCfgNport port_number command with the 1 operand. All other ports remain as F_Ports. To reset the port to an F_Port, enter the portCfgNpivPort port_number command with the disable operand. Zoning on fabric switch is incorrect. Port mapping on Access Gateway mode switch is incorrect. Cabling not properly connected. Verify zoning on the Edge switch. Verify that F_Ports are mapped to an online N_Port. See "Access Gateway default port mapping" on page 12. Perform a visual inspection of the cabling, check for issues such as wrong ports, twisted cable, or bent cable. Replace the cable and try again. Ensure the F_Port on AG module is enabled and active. Access Gateway Administrator's Guide 69 53-1001760-01