Dell PowerEdge M1000e Fabric OS Message Reference - Page 746

111 ZONE-1053 ZONE-1053 Message , [ZONE-1053], ,, INFO, , The Default Zone state is set to Disabled. Probable Cause Indicates the Interop Default Zone attribute state is disabled. Recommended Verify if the Interop Default Zone attribute state change was done on purpose. Action Severity INFO ZONE-1054 Message , [ZONE-1054], ,, WARNING, , DEFZONE ALLACCESS set with Frame Redirection zones. Probable Cause Indicates the DEFZONE allaccess mode will not grant all access behavior when frame redirection zones are defined. Recommended Remove frame redirection zones or set the defzone command to noaccess mode. Action Severity WARNING ZONE-1055 Message , [ZONE-1055], ,, WARNING, , McDATA default zone enabled with Frame Redirection zones. Probable Cause Indicates that frame redirection will not function properly with McDATA default zoning. Recommended Remove frame redirection zones or disable McDATA default zoning. Action Severity WARNING ZONE-1056 Message , [ZONE-1056], ,, WARNING, , Non-ETIZ-Capable Switch (dom ) in fabric w/ETIZ Configured. Probable Cause Indicates the config Save/Enable/Disable operations will not work with pre-6.4.0 FOS switch in IM2 fabric when ETIZ Zones are configured. Recommended Remove pre-6.4.0 FOS switch from fabric or delete Enhanced TI Zone(s). Action Severity WARNING 670 Fabric OS Message Reference 53-1001767-01