Dell PowerEdge M1000e Fabric OS Release Notes - Page 19

Blades Power Supply Requirements for Blades in 48k and DCX/DCX-4S Chassis Type of Blade 48K @200-240 VAC (Redundant configurations) DCX/DCX-4S @110 VAC (Redundant configurations) DCX/DCX-4S @200-240 VAC (Redundant configurations) Comments redundant configuration with any number of FS8-18 Blades. • For both DCX and DCX-4S with FX8-24 blades, (1+1) 220VAC Power Supplies are required for redundancy. FOS Feature Compatibility in Native Connectivity Modes Some FOS features are not fully supported when operating in the native connectivity modes for deployment with M-EOS based products. All Brocade models that are supported by Fabric OS v6.4 support both interopmodes 2 and 3 with the exception of the Brocade 4100 and 8000 and DCX/DCX-4S with one or more FCOE10-24 blades. The following table specifies the support of various FOS features when operating in either interopmode 2 (McDATA Fabric Mode) or interopmode 3 (Open Fabric Mode) with Fabric OS v6.4. FOS Features (supported in interopmode 0) FOS v6.4 IM = Interopmode IM 2 IM 3 L2 FOS Hot Code Load Yes FOS Hot Code Load with FCR Yes Zone Activation Support Yes Traffic Isolation Zones1 Yes Frame Redirection (devices attached to FOS)1 Yes Frame Redirection (devices attached to M-EOS) 1 Yes Frame Redirection over FCR10 Yes FCR Fabric Binding (route to M-EOS fabric with Fabric binding) 9 Yes L2 Fabric Binding Yes DCC policies No SCC policies Yes4 E/EX_Port Authentication Yes ISL Trunking (frame-level) Yes2 Dynamic Path Selection (DPS, exchange based routing) Yes3 Dynamic Load Sharing (DLS, port based routing) Yes Virtual Channels (VC RDY) Yes2 FICON Management Server (Cascading) Yes FICON MIHPTO Yes Full Scalability (to maximum M-EOS fabric limits) Yes Yes Yes Yes11 No Yes11 Yes11 Yes11 Yes No* No No* Yes Yes2 Yes3 Yes Yes2 No* No* Yes Fabric OS v6.4.1 Release Notes v1.0 Page 19 of 62