Dell PowerEdge M1000e 8/4 Gbps FC SAN Module Getting Started Guide - Page 9
Using the CMC GUI to set the IP address, Connecting the FC SAN Module to the Ethernet network - chassis management controller
View all Dell PowerEdge M1000e manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Using the CMC GUI to set the IP address To change the IP address, use the following steps: 1. Open the CMC application's Setup tab. 2. Enter the new information in the IP Address, Subnet Mask, and Gateway fields as appropriate and click Apply. 3. To enable DHCP, select DHCP Enabled and click Apply. FIGURE 1 CMC Setup Tab NOTE Refer to the application for additional detail. Connecting the FC SAN Module to the Ethernet network Once you have successfully set the appropriate IP address of the FC SAN Module, you can establish an Ethernet connection through the Chassis Management Controller (CMC) to a remote management workstation for any additional configuration. The management workstation must be on the same Ethernet subnet as the CMC. NOTE Ensure that the FC SAN Module is not being modified from any other connection until configuration is complete. Dell 8/4Gbps FC SAN Module Getting Started Guide 7 53-1001963-01