Dell PowerEdge M420 Dell PowerConnect M6220/M6348/M8024 Switches Configuration - Page 72
Example 2: Configuring VRRP on the Switch as a Backup Router, Enable VRRP for the switch
View all Dell PowerEdge M420 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 72 highlights
Assign virtual router IDs to the port that will participate in the protocol: console(config)#interface vlan 50 console(config-if-vlan50)#ip vrrp 20 Specify the IP address that the virtual router function will recognize. The priority default is 255. console(config-if-vlan50)#ip vrrp 20 ip 192.150.2.1 Enable VRRP on the port: console(config-if-vlan50)#ip vrrp 20 mode console(config-if-vlan50)#exit Example 2: Configuring VRRP on the Switch as a Backup Router Enable routing for the switch. IP forwarding is then enabled by default. console#config console(config)#ip routing Configure the IP addresses and subnet masks for the port that will participate in the protocol: console(config)#interface vlan 60 console(config-if-vlan60)#routing console(config-if-vlan60)#ip address 192.150.4.1 255.255.255.0 console(config-if-vlan60)#exit Enable VRRP for the switch: console#config console(config)#ip vrrp Assign virtual router IDs to the port that will participate in the protocol: console(config)#interface vlan 60 console(config-if-vlan60)#ip vrrp 20 Specify the IP address that the virtual router function will recognize. console(config-if-vlan60)#ip vrrp 20 ip 192.150.2.1 Set the priority for the port. The default priority is 100. console(config-if-vlan60)#ip vrrp 20 priority 254 72 Routing Configuration