Dell PowerEdge M420 Dell 10Gb Ethernet Pass Through II for M1000e Software Use - Page 16

Rev 1.00 3.7 Port Commands Software User's Manual 3.7.1 show port link Synopsis: show port link [port_number] Description: This command displays detailed port information. If a front (uplink) port number is specified ([port_number]), then the command displays information only for this port; otherwise, the command displays information for all the ports. The command displays the following information per port: >Port number >Port group identifier: A or B >Pass through connection status, may have one of the following values: >down - either uplink or downlink is not connected >mismatch - both uplink and downlink are connected, but there is a mismatch >Downlink port link state: > down: Link disabled (no blade present) > 10G: 10GbE link >Detailed downlink port link states (available in ADMIN level only): >10G XAUI: 10G link with fixed parameters >Uplink port link state: >empty: No module present >module_type [no link]: Module is present (module type is shown); >no link: optical fiber cable is disconnected Example: # show port link Port Group Connect Downlink Uplink 1 A 10G 10G SFP+ SR 2 A 10G 10G SFP+ SR 3 A 10G 10G SFP+ LR 4 A 10G 10G SFP+ SR 5 A 10G 10G SFP+ SR 6 A mismatch 10G SFP SX 7 A down down SFP+ SR 8 A down down empty 9 B 10G 10G SFP SX 10 B 10G 10G SFP SX 16