Dell PowerEdge M600 Fabric OS Documentation Updates - Page 14

3 portCfgFaultDelay portCfgFaultDelay Configures the fault delay for a single FC port. SYNOPSIS portcfgfaultdelay --enable [slot/]port mode portcfgfaultdelay --help DESCRIPTION Use this command to configure the fault delay of an FC port. In the event that the link is noisy after a host power cycle, the switch may go into a soft fault state, which means a delay of R_A_TOV. Setting the mode value to 1 reduces the fault delay value to 1.2 seconds. The configuration is stored in nonvolatile memory and is persistent across switch reboots or power cycle. Use the portCfgShow command to display user-configured fault delay settings. NOTES The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for details. This command is not applicable to non-FC ports. OPERANDS This command has the following operands: slot For bladed systems only, specifies the slot number of the port to be configured, followed by a slash (/). port Specifies the number of the port to be configured, relative to its slot for bladed systems. Use switchShow for a listing of valid ports. mode Specifies the fault delay value for the port number. This operand is required. Valid values are one of the following: 0 Sets the fault delay to R_A_TOV (default) 1 Sets the fault delay to 1.2 seconds. ---help Displays the command usage. EXAMPLES To set the fault delay of a port to 1.2 seconds: switch:admin> portcfgfaultdelay 2/3 1 To display the configuration switch:admin> portcfgshow 2/3 1 Area Number: 138 Speed Level: AUTO(HW) Fill Word: 0(Idle-Idle) AL_PA Offset 13: OFF Trunk Port ON Long Distance OFF VC Link Init OFF Locked L_Port OFF Locked G_Port OFF Disabled E_Port OFF ISL R_RDY Mode OFF RSCN Suppressed OFF Persistent Disable OFF NPIV capability ON QOS E_Port AE Port Auto Disable: OFF 8 Fabric OS Documentation Updates 53-1002063-03