Dell PowerEdge M605 Fabric OS Administrator’s Guide - Page 478

19 F_Port masterless trunking Example : How Trunk Area assignment affect the port Domain,Index If you have AD1: 3,7; 3,8; 4,13; 4,14 and AD2: 3,9; 3,10, and then create a TA with Index 8 with ports that have index 7, 8, 9, and 10, then index 7, 9, and 10 are no longer with domain 3. This means that AD2 does not have access to any ports because index 9 and 10 no longer exist on domain 3. This also means that AD1 no longer has 3,7in effect because Index 7 no longer exists for domain 3. AD1's 3,8, which is the TA group, can still be seen by AD1 along with 4,13 and 4,14. A port within a TA can be removed, but this adds the Index back to the switch. For example, the same AD1 and AD2 with TA 8 holds true. If you remove port 7 from the TA, it adds Index 7 back to the switch. That means AD1's 3,7 can be seen by AD1 along with 3,8; 4,13 and 4,14. When you assign an area within a trunk group, that group is F_Port masterless trunking enabled. The TA that you assign must be within the 8-port trunk group beginning with port 0 (zero). After you assign a TA to a port, the port immediately acquires the TA as the area of its PID. Likewise, after you remove a TA from a port, the port immediately acquires the default area as its PID. F_Port trunking prevents reassignments of the Port ID also referred to as the Address Identifier. Table 90 shows an example of an Address Identifier. TABLE 90 Address identifier 23 22 21 20 19 18 17 16 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0 Domain ID Address Identifier Area_ID Port ID 1. Connect to the switch and log in using an account assigned to the admin role. 2. Enter the portDisable command for each port to be included in the TA. 3. Enter the portTrunkArea --enable command to enable the Trunk Area for ports 36-39 with index number 37. switch:admin> porttrunkarea --enable 36-39 -index 37 Trunk index 37 enabled for ports 36, 37, 38 and 39. When you assign a trunk area on a port, it enables trunking on the F_Ports automatically. This command does not unassign a TA if its previously assigned Area_ID is the same address identifier (Area_ID) of the TA unless all the ports in the trunk group are specified to be unassigned. 4. Re-enable ports 36-39 by issuing portEnable for each port in the TA. 5. Enter the switchshow command to display the switch and port information. 6. Enter the porttrunkarea --show enabled command to display the TA-enabled port configuration. switch:admin> porttrunkarea --show enabled Port Type State Master TA DA 36 F-port Master 36 37 36 37 F-port Slave 36 37 37 38 F-port Slave 36 37 38 39 F-port Slave 36 37 39 7. Enter the porttrunkarea --show trunk command to display the trunking information. switch:admin> porttrunkarea --show trunk Trunk Index 37: 39->0 sp: 8.000G bw: 16.000G deskew 15 MASTER Tx: Bandwidth 16.00Gbps, Throughput 1.63Gbps (11.84%) 438 Fabric OS Administrator's Guide 53-1001763-02