Dell PowerEdge M910 Fabric OS Message Reference - Page 699
SWCH System Messages, SWCH-1001
View all Dell PowerEdge M910 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 699 highlights
Chapter SWCH System Messages 98 SWCH-1001 Message , [SWCH-1001], ,, ERROR, , Switch is not in ready state - Switch enable failed switch status= 0x, c_flags = 0x. Probable Cause Indicates the switch is enabled before it is ready. Recommended If the message persists, run the supportFtp command (as needed) to set up automatic FTP Action transfers; then run the supportSave command and contact your switch service provider. Severity ERROR SWCH-1002 Message , [SWCH-1002], ,, INFO, , Security violation: Unauthorized device tries to flogin to port . Probable Cause Indicates the device is not present in the authorized profile list. Recommended Action Verify the device is authorized to log in to the switch. If the device is authorized, run the secPolicyDump command to verify whether the specified device world wide name (WWN) is listed. If it is not listed, run the secPolicyAdd command to add this device to an existing policy. Severity INFO SWCH-1003 Message , [SWCH-1003], ,, ERROR, , Slot ENABLED but Not Ready during recovery, disabling slot = (). Probable Cause Indicates the slot state has been detected as inconsistent during failover or recovery. Recommended Action On a Brocade 24000 or 48000 switch, run the slotPowerOff command and then the slotPowerOn command. On a Brocade 7500 or AP7600 switch, reboot or power cycle the switch. Severity ERROR Fabric OS Message Reference 623 53-1001767-01