Dell PowerEdge M910 Fabric OS Message Reference - Page 755

AUDIT AUTH System Messages Chapter 114 AUTH-1045 Message AUDIT, , [AUTH-1045], ,, ERROR, , Certificate not present in this switch in port . Probable Cause Indicates that the public key infrastructure (PKI) certificate is not installed in this switch. Recommended Action Check the certificate availability using the pkiShow command. Install the certificate and reinitialize authentication using the portDisable and portEnable commands or the switchDisable and switchEnable commands. If the message persists, run supportFtp command (as needed) to set up automatic FTP transfers; then run the supportSave command and contact your switch service provider. Severity ERROR AUTH-1046 Message AUDIT, , [AUTH-1046], ,, INFO, , has been successfully completed. Probable Cause Indicates that the certificate database operation has been updated using the secAuthCertificate command. The values for Operation type can be "set" or "remove". Recommended No action is required. Action Severity INFO AUTH-1047 Message AUDIT, , [AUTH-1047], ,, ERROR, , has failed. Probable Cause Indicates that the specified action has failed to update the certificate database using the secAuthCertificate command. The values for Operation type can be "set" or "remove". Recommended Action Retry the secAuthCertificate command. Run supportFtp (as needed) to set up automatic FTP transfers; then run the supportSave command and contact your switch service provider. Severity ERROR Fabric OS Message Reference 679 53-1001767-01