Dell PowerEdge R200 Information Update
Dell PowerEdge R200 Manual
 |
View all Dell PowerEdge R200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Dell PowerEdge R200 manual content summary:
- Dell PowerEdge R200 | Information Update - Page 1
damage, personal injury, or death. Information Update SUSE® Linux Enterprise Server 9 Installation Notes SATA optical disk drives are not supported by SUSE Linux Enterprise Server 9 SP3. The following error messages may appear when attempting to install the operating system from a SATA optical - Dell PowerEdge R200 | Information Update - Page 2
. See "Opening the System" in your Hardware Owner's Manual. 3 Disconnect the SATA power and data cables from the optical drive. See Figure 1. 4 Press the bracket release lever that secures the optical drive to the hard drive 0 carrier. 5 Lift and tilt the optical drive up and out of the bracket. - Dell PowerEdge R200 | Information Update - Page 3
Figure 1. Removing and Installing the Optional SATA Optical Drive 1 2 3 4 6 5 1 SATA data cable 4 mounting holes (4) 2 SATA power cable 5 bracket release lever 3 retaining pins (4) 6 hard drive 0 Installing the Optical Drive CAUTION: Only trained service technicians are authorized to remove - Dell PowerEdge R200 | Information Update - Page 4
reserved. Printed in Malaysia. Reproduction in any manner whatsoever without the written permission of Dell Inc. is strictly forbidden. Trademarks used in this text: Dell and the DELL logo are trademarks of Dell Inc.; SUSE is a registered trademark of Novell, Inc. in the United States and other - Dell PowerEdge R200 | Information Update - Page 5
关于警告 信息更新 SUSE® Linux Enterprise Server 9 SUSE Linux Enterprise Server 9 SP3 不支持 SATA SATA cannot read media device not mounted NIC1 USB CPU Information（CPU DemandBased Power Management Enabled SAS RAID SAS RAID PCI RAID SAS RAID PCI SAS RAID SAS RAID PCI 2008 年 6 - Dell PowerEdge R200 | Information Update - Page 6
SATA 1 2 3 SATA 1。 4 0 5 - Dell PowerEdge R200 | Information Update - Page 7
图 1 SATA 1 2 3 4 6 5 1 SATA 4 4 个） 2 SATA 5 3 4 个） 6 0 - Dell PowerEdge R200 | Information Update - Page 8
1 0 1。 2 3 将 SATA 4 2007-2008 Dell Inc Dell Inc Dell 和 Dell 徽标是 Dell Inc SUSE 是 Novell Inc Dell Inc - Dell PowerEdge R200 | Information Update - Page 9
tentez d'installer le système d'exploitation à partir d'un lecteur optique SATA, il est possible que le système affiche les messages d'erreur suivants pour indiquer qu'il ne parvient pas à lire le support et que le périphérique n'est pas monté : cannot read media device not mounted Pour résoudre - Dell PowerEdge R200 | Information Update - Page 10
d'installation du ) dans le document Hardware Owner's Manual (Manuel du proprié taire). 3 Déconnectez les câbles de données et d'alimentation SATA enfichés dans le lecteur optique. Voir figure 1. 4 Appuyez sur le levier d'éjection qui fixe le lecteur optique au support - Dell PowerEdge R200 | Information Update - Page 11
Figure 1. Retrait et installation du lecteur optique SATA en option 1 2 3 4 6 5 1 Câble de données SATA 2 Câble d'alimentation 3 Plots de retenue (4) SATA 4 Orifices de montage (4) 5 Levier d'éjection 6 Disque dur 0 - Dell PowerEdge R200 | Information Update - Page 12
support du disque dur 0. Voir figure 1. 2 Faites pivoter le disque vers le bas jusqu'à ce qu'il s'enclenche. 3 Connectez les câbles de données et d'alimentation SATA au lecteur optique. 4 Refermez le système. Voir "Closing the System" (Fermeture du système) dans le document Hardware Owner's Manual - Dell PowerEdge R200 | Information Update - Page 13
-Laufwerke werden von SUSE Linux Enterprise Server 9 SP3 nicht unterstützt. Beim Versuch, das Betriebssystem von einem optischen SATA-Laufwerk zu installieren, erscheint möglicherweise die folgende Fehlermeldung: cannot read media device not mounted Um dieses Problem zu umgehen, installieren Sie das - Dell PowerEdge R200 | Information Update - Page 14
-Gerät. Wenn Sie einen SAS-RAID-Controller für externen Speicher bestellt haben, der einen PCI-Lüfter benötigt, so war dieser Lüfter im Installations-Kit enthalten. Wenn das Kit keinen Lüfter enthält, ist für diesen Controller kein Lüfter erforderlich. Aus- und Einbau des optionalen optischen SATA - Dell PowerEdge R200 | Information Update - Page 15
Abbildung 1. Aus- und Einbauen des optionalen optischen SATA-Laufwerks 1 2 3 4 6 5 1 SATA-Datenkabel 2 SATA-Stromversorgungs- 3 Haltestifte (4) -kabel 4 Montagelöcher (4) 5 Freigabehebel der Halterung 6 Festplatte 0 - Dell PowerEdge R200 | Information Update - Page 16
. Irrtümer und technische Änderungen vorbehalten. © 2007-2008 Dell Inc. Alle Rechte vorbehalten. Gedruckt in Malaysia. Nachdrucke jeglicher schriftliche Genehmigung von Dell Inc. sind strengstens untersagt. In diesem Text verwendete Marken: Dell und das DELL-Logo sind Marken der Dell Inc.; SUSE - Dell PowerEdge R200 | Information Update - Page 17
SUSE® Linux Enterprise Server 9 SUSE Linux Enterprise Server 9 SP3 は SATA SATA OS cannot read media device not mounted NIC1 USB OS CPU Information（CPU Demand-Based Power Management Enabled 2008 年 6 月 - Dell PowerEdge R200 | Information Update - Page 18
SAS RAID PCI SAS RAID PCI RAID SAS RAID SAS RAID PCI SAS RAID SATA 1 2 3 SATA 1 4 0 5 - Dell PowerEdge R200 | Information Update - Page 19
図 1 SATA 1 2 3 4 6 5 1 SATA 2 SATA 4 4） 5 3 4） 6 0 - Dell PowerEdge R200 | Information Update - Page 20
1 0 1 2 3 SATA 4 2007-2008 Dell Inc Printed in Malaysia. Dell Inc Dell および DELL ロゴは Dell Inc SUSE Novell, Inc Dell Inc - Dell PowerEdge R200 | Information Update - Page 21
SUSE® Linux Enterprise Server 9 SATA SUSE Linux Enterprise Server 9 SP3 SATA cannot read media device not mounted NIC1 USB System Setup CPU Information (CPU DemandBased Power Management Enabled SAS RAID PCI SAS RAID PCI RAID SAS RAID SAS RAID PCI SAS RAID - Dell PowerEdge R200 | Information Update - Page 22
SATA 1 2 3 SATA 1 4 0 5 - Dell PowerEdge R200 | Information Update - Page 23
그림 1. SATA 1 2 3 4 6 5 1 SATA 4 4) 2 SATA 5 3 4) 6 0 - Dell PowerEdge R200 | Information Update - Page 24
1 0 1 2 3 SATA 4 2007-2008 Dell Inc Dell Inc Dell 및 DELL 로고는 Dell Inc SUSE Novell, Inc Dell Inc - Dell PowerEdge R200 | Information Update - Page 25
9 SUSE Linux Enterprise Server 9 SP3 no admite unidades de disco óptico SATA. Al intentar instalar el sistema operativo desde una unidad óptica SATA, pueden aparecer los mensajes de error siguientes: cannot read media device not mounted Para resolver este problema, instale el sistema operativo desde - Dell PowerEdge R200 | Information Update - Page 26
el sistema de la toma eléctrica y los dispositivos periféricos. 2 Abra el sistema. Consulte "Apertura del sistema" en el Manual del propietario del hardware. 3 Desconecte los cables SATA de alimentación y de datos de la unidad óptica. Vea la ilustración 1. 4 Presione la palanca de liberaci - Dell PowerEdge R200 | Information Update - Page 27
Ilustración 1. Extracción e instalación de la unidad óptica SATA opcional 1 2 3 4 6 5 1 Cable de datos SATA 2 4 Orificios de montaje (4) 5 Cable de alimentación 3 SATA Palanca de liberación 6 del soporte Patas de retención (4) Unidad de disco duro 0 - Dell PowerEdge R200 | Information Update - Page 28
la unidad óptica. 4 Cierre el sistema. Consulte "Cierre del sistema" en el Manual del propietario del hardware. La información contenida en este documento puede modificarse sin previo aviso. © 2007-2008 Dell Inc. Todos los derechos reservados. Impreso en Malasia. Queda estrictamente prohibida la
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
-
17
-
18
-
19
-
20
-
21
-
22
-
23
-
24
-
25
-
26
-
27
-
28
 |
 |
About Cautions
A CAUTION indicates a potential for property damage, personal injury, or death.
Information Update
SUSE
®
Linux Enterprise Server 9
Installation Notes
SATA optical disk drives are not supported by SUSE Linux Enterprise
Server 9 SP3. The following error messages may appear when attempting
to install the operating system from a SATA optical drive:
cannot read media
device not mounted
To resolve this issue, install the operating system from the network
(using the NIC1 connector), or from an external USB optical drive.
System Setup Program Update
On the
CPU Information
screen of the System Setup Program, the default
setting for the
Demand-Based Power Management
option is
Enabled
.
SAS RAID Controller Fan Update
Your system supports an external-storage SAS RAID controller that does not
require a PCI cooling fan, contrary to the information stated in your system
user documentation. A PCI fan is required only for the external-storage SAS
RAID controller that has a RAID battery connector on the card. See the user
documentation for your SAS RAID device for more information.
If you ordered an external-storage SAS RAID controller that requires the PCI
fan, the fan was included in the installation kit. If no fan was included with
your kit, the fan is not required for that controller.
June 2008