Dell PowerEdge R710 Getting Started Guide   - Page 10

Obtaining Technical Assistance If you do not understand a procedure in this guide or if the system does not perform as expected, see your Hardware Owner's Manual. Dell™ offers comprehensive hardware training and certification. See www.dell.com/training for more information. This service may not be offered in all locations. Technical Specifications Processor Processor type Expansion Bus Bus type Expansion slots via riser card: Riser 1 (Center Riser) Riser 2 (Left Riser) Memory Architecture Memory module sockets Memory module capacities Minimum RAM Maximum RAM One or two quad- or dual-core Intel® Xeon® processors PCI Express Generation 2 One full-height, 9.5-inch length, x4 link (slot 1) NOTE: This slot can be upgraded to 12.2 inches. One low-profile, 9.5-inch length, x4 link (slot 2) Two full-height, 9.5-inch length, x8 link (slot 3 and 4) or One full-height, 9.5-inch length, x16 link (slot 3) NOTE: Support for up to 25W is available only on the first two cards installed in the system; any additional cards installed in the system must be 15W or under. 800, 1066, or 1333 MHz DDR3 registered or unbuffered Error Correcting Code (ECC) DIMMs. Support for Advanced ECC or Memory Optimized operation. Eighteen 240-pin 1 GB and 2 GB UDIMMs, and 2 GB, 4 GB, or 8 GB RDIMMs (single, dual, or quad-rank dependent on capacity) 1 GB with a single processor (1 DIMM per processor) 96 GB (with quad-rank 8 GB RDIMM), 144 GB (with dual-rank 8 GB RDIMM), or 24 GB (with 2 GB UDIMMs) 8 Getting Started With Your System