Dell PowerEdge R740xd2 iDRAC9 with Lifecycle Controller Version 3.30.30.30 RAC - Page 148

Examples • -f-target filename for the exported log. NOTE: The filename must have .zip as the extension. • To collect the system information data. racadm techsupreport collect -t • To collect the system information and TTYLog data. racadm techsupreport collect -t SysInfo,TTYLog • To collect the operating system application data. racadm techsupreport collect -t OSAppAll • To export the collected Tech Support Report, to an FTP share racadm techsupreport export -l ftp://192.168.0/share -u myuser -p xxx • To export the collected Tech Support Report, to a TFTP share racadm techsupreport export -l tftp://192.168.0/share • To export the collected Tech Support Report, to a CIFS share. racadm techsupreport export -l //192.168.0/share -u myuser -p xxx • To export the collected Tech Support Report, to an NFS share. racadm techsupreport export -l 192.168.0:/share • To export the collected Tech Support Report to the local file system. racadm techsupreport export -f tsr_report.zip testemail Table 104. Details of testemail Description Sends a test email from iDRAC to a specified destination. Prior to running the test email command, make sure that the SMTP server is configured. The specified index in the idrac.EmailAlert group must be enabled and configured properly. For more information, see iDRAC RACADM CLI Guide available at www.dell.com/idracmanuals. Synopsis Input Output Example racadm testemail -i -i - Specifies the index of the email alert to test. Success: Test e-mail sent successfully Failure: Unable to send test e-mail Commands for the idrac.EmailAlert group: • Enable the alert. racadm set idrac.EmailAlert.1.Enable 1 • Set the destination email address. racadm set idrac.EmailAlert.1.Address [email protected] • Set the custom message that is sent to the destination email address. racadm set idrac.emailalert.1.CustomMsg "This is a test!" 148 RACADM Subcommand Details