Dell PowerEdge SDS 100 Dell Processor Acceleration Technology - Page 3

Enabling and Disabling DPAT Using WSMAN

To enable or disable DPAT using WSMAN, run the following command:

winrm i SetAttribute

http://schemas.dmtf.org/wbem/wscim/1/cim-

schema/2/root/dcim/DCIM_BIOSService?SystemCreationClass

Name=DCIM_ComputerSystem+CreationClassName=

DCIM_BIOSService+SystemName=DCIM:ComputerSystem+Name=

DCIM:BIOSService -u:%1 -p:%2 -r:https://%3/wsman -

SkipCNcheck -SkipCAcheck -SkipRevocationCheck -

encoding:utf-8 -a:basic -file:set_controlled_turbo.xml

NOTE:

Replace %1 with iDRAC userID, %2 with iDRAC password and %3 with the

iDRAC IP.

Enabling Turbo Using WSMAN

To enable turbo using WSMAN, use the following content for

set_controlled_turbo.xml

:

<p:SetAttribute_INPUT xmlns:p=

"http://schemas.dmtf.org/wbem/wscim/1/cim-

schema/2/root/dcim/DCIM_BIOSService">

<p:Target>BIOS.Setup.1-1</p:Target>

<p:AttributeName>ControlledTurbo</p:AttributeName>

<p:AttributeValue>Enabled</p:AttributeValue>

</p:SetAttribute_INPUT>

Disabling Turbo Using WSMAN

To disable turbo using WSMAN, use the following content for

set_controlled_turbo.xml

:

<p:SetAttribute_INPUT xmlns:p=

"http://schemas.dmtf.org/wbem/wscim/1/cim-

schema/2/root/dcim/DCIM_BIOSService">

<p:Target>BIOS.Setup.1-1</p:Target>

<p:AttributeName>ControlledTurbo</p:AttributeName>

<p:AttributeValue>Disabled</p:AttributeValue>

</p:SetAttribute_INPUT>

Section	Page
Dell Processor Acceleration Technology	1
Introduction	1
Enabling DPAT	1
Enabling DPAT Using RACADM (Firmware RACADM: SSH or Telnet Session)	2
Disabling DPAT Using RACADM (Firmware RACADM: SSH or Telnet Session)	2
Enabling and Disabling DPAT Using WSMAN	3
Enabling DPAT Using DTK	4

Dell PowerEdge SDS 100 Dell Processor Acceleration Technology - Page 3

Enabling and Disabling DPAT Using WSMAN, Enabling Turbo Using WSMAN

Page 3 highlights