Dell PowerEdge T110 II Owner's Manual - Page 65
Expansion-Card Stabilizer, Removing the Expansion-Card Stabilizer
View all Dell PowerEdge T110 II manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 65 highlights
10 Exit the System Setup program and reboot the system. 11 Partition and logically format the drive. See the documentation that came with the drive for instructions on installing any software required for drive operation. Expansion-Card Stabilizer Removing the Expansion-Card Stabilizer CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product. 1 Turn off the system and attached peripherals. Disconnect the system from the electrical outlet and peripherals. 2 Open the system. See "Opening the System" on page 45. 3 Press the release tab and lift the expansion card stabilizer out of slots in the chassis. See Figure 3-15. Installing the Expansion-Card Stabilizer CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product. 1 Slide the edge of the expansion-card stabilizer into the slots in the cooling shroud and chassis until the release tab locks into place. See Figure 3-15. 2 Close the system. See "Closing the System" on page 46. Installing System Components 65