Dell PowerEdge T410 Information Update - Processor Installation - Page 3

Information Update on Processor Installation Removing a Processor WARNING: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system. Before you begin this procedure, review the safety instructions that came with the system. 1 Prior to upgrading your system, download the latest system BIOS version from support.dell.com and follow the instructions included in the compressed download file to install the update on your system. 2 Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet. When disconnected from AC power, press and hold the power button for 3 seconds to fully drain the system of stored power prior to removing the cover. NOTE: It is recommended that you always use a static mat and static strap while working on components in the interior of the system. 3 Open the system. See "Opening the System" in the Hardware Owner's Manual. 4 Remove the cooling shroud. See "Removing the Cooling Shroud" in the Hardware Owner's Manual. WARNING: The heat sink and processor are hot to the touch for some time after the system has been powered down. Allow the heat sink and processor to cool before handling them. CAUTION: Never remove the heat sink from a processor unless you intend to remove the processor. The heat sink is necessary to maintain proper thermal conditions. 5 Release one of the heat-sink release levers or remove the screws from the corners of the heat sink. See your Hardware Owner's Manual for a system-specific illustration. See Figure 1-1. 6 Wait 30 seconds for the heat sink to loosen from the processor. 7 Release the other heat-sink release lever. 8 Gently lift the heat sink off of the processor and set the heat sink aside upside down (thermal grease side facing up). Processor Installation 3