Dell PowerSwitch S4112F-ON EMC SmartFabric OS10 User Guide Release 10.5.0 - Page 667

Enable OSPFv2 configuration OS10(config)# ip vrf vrf-blue OS10(config-vrf-blue)# router ospf 100 vrf-blue OS10(conf-router-ospf-100)# exit OS10(config)# interface ethernet 1/1/2 OS10(conf-if-eth1/1/2)# no shutdown OS10(conf-if-eth1/1/2)# no switchport OS10(conf-if-eth1/1/2)# ip vrf forwarding vrf-blue OS10(conf-if-eth1/1/1)# ip address 11.1.1.1/24 OS10(conf-if-eth1/1/1)# ip ospf 100 area 0.0.0.0 NOTE: If you want to move an interface associated with one VRF instance to another default or non-default VRF instance, you must first remove the OSPF or Layer3 configurations that already exist on the interface. If you move the interface from one VRF instance to another without removing these existing Layer3 or OSPF configurations, these configurations do not take effect in the new VRF instance. Consider a scenario where the OSPF instance 100 is configured on the default VRF instance and the OSPF instance 200 is configured on the non-default VRF instance named VRF-Red. The interface eth1/1/1 on the default VRF instance is attached to an OSPF process 100 area 1. In this scenario, if you want to move eth1/1/1 from the default VRF instance to VRF-Red, you must first remove the OSPF area configuration to which the interface eth1/1/1 is currently attached to. Assign router identifier For managing and troubleshooting purposes, you can assign a router ID for the OSPFv2 process. Use the router's IP address as the router ID. • Assign the router ID for the OSPFv2 process in ROUTER-OSPF mode router-id ip-address Assign router ID OS10(config)# router ospf 10 OS10(conf-router-ospf-10)# router-id 10.10.1.5 View OSPFv2 status OS10# show ip ospf 10 Routing Process ospf 10 with ID 10.10.1.5 Supports only single TOS (TOS0) routes It is an Autonomous System Boundary Router It is Flooding according to RFC 2328 Convergence Level 0 Min LSA origination 0 msec, Min LSA arrival 1000 msec Min LSA hold time 5000 msec, Max LSA wait time 5000 msec Number of area in this router is 1, normal 1 stub 0 nssa 0 Area (0.0.0.0) Number of interface in this area is 3 SPF algorithm executed 38 times Area ranges are Stub areas Type 5 LSAs are not flooded into stub areas. The ABR advertises a default route into the stub area where it is attached. Stub area routers use the default route to reach external destinations. 1. Enable OSPF routing and enter ROUTER-OSPF mode, from 1 to 65535. router ospf instance number 2. Configure an area as a stub area in ROUTER-OSPF mode. area area-id stub [no-summary] Layer 3 667