Dell PowerVault 114T 2U Rack Installation Guide (.pdf)
Dell PowerVault 114T 2U Manual
 |
View all Dell PowerVault 114T 2U manuals
Add to My Manuals
Save this manual to your list of manuals |
Dell PowerVault 114T 2U manual content summary:
- Dell PowerVault 114T 2U | Rack
Installation Guide (.pdf) - Page 1
www.dell.com | support.dell.com Installation and Removal Instructions for Dell PowerVaultTM 114T FX973 Ferrite Core Kit If ferrites are present, there is no need to replace or install new ones. When replacing SCSI cables or power supplies - Dell PowerVault 114T 2U | Rack
Installation Guide (.pdf) - Page 2
www.dell.com | support.dell.com SCSI Cables - Ferrite Installation Remove the backing from the adhesive tape and adhere the open ferrites to the back bays underneath the SCSI cables (see Figure 1-4). Figure 1-3. Open Ferrite for SCSI Cable Figure 1-4. Ferrites Adhered to the Back Bays - Dell PowerVault 114T 2U | Rack
Installation Guide (.pdf) - Page 3
www.dell.com | support.dell.com Close the ferrites to complete the installation on SCSI cables (see Figure 1-5). Figure 1-5. Ferrites Installed on SCSI Cables Refer to Figure 1-6 for the completed - Dell PowerVault 114T 2U | Rack
Installation Guide (.pdf) - Page 4
www.dell.com | support.dell.com Adding Ferrites to New SCSI Cables or Power Supply Use your fingers and/or a flat blade screwdriver to pry open the ferrites surrounding the - Dell PowerVault 114T 2U | Rack
Installation Guide (.pdf) - Page 5
www.dell.com | support.dell.com - Dell PowerVault 114T 2U | Rack
Installation Guide (.pdf) - Page 6
support.dell.com Information in this document is subject to change without notice. © 2007 Dell Inc. All rights reserved. Printed in the U.S.A. Reproduction in any manner whatsoever without the written permission of Dell Inc. is strictly forbidden. Trademarks used in this text: Dell and the DELL
-
1 -
2 -
3 -
4 -
5 -
6
 |
 |
www.dell.com | support.dell.com
Installation and Removal Instructions for Dell PowerVault
TM
114T
If ferrites are present, there is no need to replace or install new ones. When replacing SCSI cables or power
supplies with ferrites attached, refer to
Adding Ferrites to New SCSI Cables or Power Supply
to open ferrites.
Power Cables – Ferrite Installation
Place one ferrite on each of the power cables that connect to the tape drive (see Figure 1-2).
Figure 1-1.
Open Ferrite for Power Cable
Figure 1-2.
Ferrites Installed on Power Cables
October 2007
FX973 Ferrite Core Kit