Dell PowerVault 200S Dell PowerVault 20xS Storage Systems Enclosure Services - Page 10
Dell PowerVault 20xS Storage System Installation and Service Guide - specifications
View all Dell PowerVault 200S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
This section provides service procedures for the PowerVault 20xS storage system. Refer to the Dell PowerVault 20xS Storage System Installation and Service Guide for troubleshooting information. NOTE: In a cluster configuration, you must turn off any server nodes connected to the PowerVault 20xS storage system while you replace an enclosure services expander module. When you need to replace the A enclosure services expander module in a redundant storage system, replace it with the B enclosure services expander module. Then replace the B enclosure services expander module with a new one. In a redundant configuration, the A enclosure services expander module copies system-specific information to the B enclosure services expander module. Both modules retain the same information. By replacing the A module with the B module and then installing the new module in the B enclosure services expander module bay, what is now the A enclosure services expander module copies the system-specific information to the new B enclosure services expander module. If you need to replace only the B enclosure services expander module, replace it with a new enclosure services expander module. To replace the enclosure services expander module, perform the following steps. 1. Turn off the storage system. 2. Disconnect the power cable(s) from the electrical outlet and the power supply. 3. Disconnect any SCSI cables between the module and the server. 4. Using a Phillips-head screwdriver, loosen the captive screw at the top of the enclosure services expander module (see Figure 1-2). 5. Grasp the handle on the enclosure services expander module and pull it from the module bay. 6. Carefully insert the replacement enclosure services expander module into the module bay. 7. Push the module to the back of the bay until it is seated in the connector. The module is seated when its front plate is even with the neighboring components. 1-8 Dell PowerVault 20xS Storage Systems Enclosure Services Expander Module Installation