Dell PowerVault 56F Dell PowerVault Switch Manager User's Guide - Page 17

Refresh button Domain # field Port # field Port ID field Port Type field Port WWN field Node WWN field Symbolic Name field FC4 Types field (not shown in Figure 2-3) COS field (not shown in Figure 2-3) Member of Zones field (not shown in Figure 2-3) Done button Click to refresh on demand Displays the domain ID of a switch to which each device is connected Displays the port number of the switch Displays the port ID of a device (Fibre Channel 24-bit ID in hexadecimal) Displays the port type of a device (N for fabric direct attached port or NL for fabric direct attached loop port) Displays the WWN for a device port Displays the WWN for a device node Displays the symbolic name of a device reported by the SCSI INQUIRY command Displays the Fibre Channel FC4 layer types supported by device, such as IP and FCP Displays the Fibre Channel classes of service supported by the device Lists all the zones of which the device is a member Click to close the window The Zone Administration consists of the following functions: Zone Alias Settings Zone Settings Zone Config Settings NOTE: You should make Zone Administration changes incrementally. Changes to the zoning information are transferred to the switches only when you click Apply; if you have made a large number of changes, the fabric can become unusable while the information is being updated on all the switches in the fabric. Dell recommends that you click Apply to update the changes frequently when modifying the zoning information. support.dell.com Using the Dell PowerVault Switch Manager 2-7