Dell PowerVault 725N Information Update for Systems With Hardware RAID - Page 10
Install the replacement converter board - hard drive
View all Dell PowerVault 725N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
www.dell.com | support.dell.com 9 Install the replacement converter board: a Align the holes in the board with the guide pins on the bottom of the chassis, lower the board into the system, and slide the board forward 1 cm (0.5 inch). b Replace the two screws that you removed in step 8. 10 Install the replacement power supply by inserting the guide pins on the power supply into the guide-pin slots on the chassis, lowering the power supply into the chassis, and then pushing the power supply toward the front of the system. See Figure 1-7. Figure 1-7. Removing and Replacing the Power Supply power supply power-supply cable plastic insert screws (2) converter board chassis guide pins (2) hard drive 3 1-8 Information Update power-supply guide pins (2) guide-pin slots (2)