Dell PowerVault DX6112 Dell DR Series System Command Line Reference Guide - Page 37
address>]
![]() |
View all Dell PowerVault DX6112 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
Syntax network --setstatic_ip --ip 10.20.20.20 --netmask 255.255.222.0 --gateway 10.25.20.10 Result Bond device operation successful. Please run 'network --restart' for the changes to take effect. network --setdns [--suffix ] [--primary ] [--secondary ] Description Configures the domain name system (DNS) for a DR Series system, which includes the corresponding DNS suffix and a primary name server IP address (and optionally, a secondary name server IP address). Syntax network --setdns --suffix storage.local --primary 10.25.20.21 --secondary 10.25.20.25 network --setbonding [--mode ] [--mtu ] Description Configures or updates the bonding mode or sets the maximum transmission unit (MTU) number to use for a DR Series system. Syntax network --setbonding --mode ALB --mtu 1750 Result Bond device operation successful. Please run 'network --restart' for the changes to take affect. NOTE: ALB load balancing does not balance the load properly when the backup servers are on a remote subnet. This is because ALB uses the address resolution protocol (ARP) and ARP updates are subnet-specific. Because of this, ARP broadcasts and updates are not sent across the router. Instead, all traffic is sent to the first interface in the bond. To resolve this ARP-specific issue, make sure that the data source systems reside on the same subnet as the DR Series system. NOTE: When setting or changing the MTU value, make sure to verify that the Ethernet network switch is capable of supporting an MTU size that is equal to or larger than the value being set. Any mismatch in MTU values between the clients, the Ethernet network switch, and the DR Series system will make it inoperable. The relationship of jumbo frames to MTU is discussed in this topic. NOTE: When using the DR Series system CLI --setbonding and --mtu commands, a warning dialog displays with the following message: Incorrectly setting the MTU size will cause the DR4000 to not respond. You will need to log in to the system console and use the network --setbonding --mtu 1500 command to resolve the issue. Please verify that the switch is enabled and capable of supporting an 37
![](/manual_guide/products/dell-powervault-dr4100-dell-dr-series-command-line-reference-guide-d0f78b0/37.png)