Dell PowerVault MD3400 Owners Manual - Page 19
Installing a 3.5 Inch Physical-Drive Blank, Removing a Hot-Swap Physical Drive - software
View all Dell PowerVault MD3400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
Figure 10. Removing and Installing a 3.5 Inch Hard-Drive Blank (MD3400 only) 1. physical-drive blank 2. release button Installing a 3.5 Inch Physical-Drive Blank 1. If installed, remove the front bezel. 2. Insert the physical-drive blank into the physical-drive slot until the release button clicks into place. 3. If applicable, install the front bezel. Removing a Hot-Swap Physical Drive CAUTION: To prevent data loss, ensure that your operating system supports hot-swap drive installation. See the documentation supplied with your operating system. 1. From the management software, prepare the physical drive for removal. Wait until the indicators on the physical-drive carrier signal that the physical drive can be removed safely. For more information, see the documentation for the storage controller. If the physical drive is online, the green activity/fault indicator flashes as the drive is turned off. When the physical-drive indicators are off, the physical drive is ready for removal. 2. Press the release button to open the physical-drive carrier release handle. 3. Slide the physical-drive carrier out until it is free of the physical-drive slot. CAUTION: To maintain proper system cooling, all empty physical-drive slots must have physical-drive blanks installed. 4. Insert a physical-drive blank in the empty physical-drive slot. 19