Dell PowerVault NX1950 Deployment Guide (Configuration procedures on you - Page 23
Con the Hard Drive for Microsoft, Dell Systems Build and Update Utility - setup
View all Dell PowerVault NX1950 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
If you are using the Dell Systems Build and Update Utility on your system for the first time, perform the following steps: a When prompted, click the appropriate language for your system. The Dell Software License Agreement window appears. Read the information carefully. b If you agree with all of the information, click Accept to continue. If you do not agree with all the information, click Decline. Your system restarts, and you will not able to complete the operating system installation. 5 Click Server Setup to install the operating system. The Set the Date and Time window appears. 6 Select the appropriate date, time, and time zone, and click Continue. 7 Select Microsoft Windows Server 2003 x64 Edition. NOTE: Select Microsoft Windows Server® 2003 x64 Edition. NOTE: Since the product identification (PID) is included on the operating system media, providing your PID is not required. You are only prompted to enter a PID during the Server Administrator installation if you use Dell OpenManage 5.0 or earlier. 8 Click Continue. The Configure the Hard Drive for Microsoft window appears. 9 The Configure or Skip RAID window appears. Perform the following steps: a Select one of the following options, and then click Continue: • Configure RAID • Skip RAID configuration NOTE: Your system was pre-configured with hardware RAID1 using both the internal hard disk drives, and this is the only supported hardware configuration for your system. b If you selected Skip RAID configuration, go to step 10. Deployment Guide 23