Dell Precision M4500 Service Manual - Page 24
Display Assembly
View all Dell Precision M4500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
Back to Contents Page Display Assembly Dell Precision™ Mobile Workstation M4500 Service Manual WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance. Removing the Display Assembly NOTE: You may need to install Adobe™ Flash Player™ from Adobe.com in order to view the illustrations below. 1. Follow the procedures in Before Working Inside Your Computer. 2. Remove the battery. 3. Remove the access panel. 4. Remove the hinge covers. 5. Loosen the captive screws that secure the display cable to the system board and disconnect the display cable from its connector on the system board. 6. Disconnect and release the antenna cables from wireless local area network (WLAN) card. 7. Remove the screws that secure the display assembly to the computer. 8. Disconnect and release the antenna cables from wireless wide area network (WWAN) card. 9. Remove the screws that secure the display assembly to the computer. 10. Lift the display assembly up and away from the computer. Replacing the Display Assembly To replace the display assembly, perform the above steps in reverse order. Back to Contents Page