Dell S5224F-ON Open Networking Hardware Diagnostic Guide December 2021 - Page 72
Table 1. SmartFusion FPGA registers, Copy needed binaries, Check FPGA region
View all Dell S5224F-ON manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 72 highlights
Figure 11. Copy needed binaries 2. Check the FPGA region using smarttool -gfr /dev/ttyS0 command. Figure 12. Check FPGA region 3. Get the current version of the FPGA using the lpctool utility. Get the FPGA running image version through the ./ lpctool --read --addr=0x200 --size=b registers at the LPC tool. Table 1. SmartFusion FPGA registers Offset 0x200 Name SMF_VER Description SmartFusion FPGA version register Figure 13. Get current FPGA version 4. Upgrade the FPGA in smartFusion using the # ./smarttool -uf /dev/ttyS0 / _SMF_logic_v0.E.dat command. To upgrade to region A, you must be in region G. The device automatically reboots after the upgrade. 72 Dell EMC DAIG-OS tools
Figure 11. Copy needed binaries
2.
Check the FPGA region using
smarttool –gfr /dev/ttyS0
command.
Figure 12. Check FPGA region
3.
Get the current version of the FPGA using the
lpctool
utility. Get the FPGA running image version through the
./
lpctool --read --addr=0x200 --size=b
registers at the LPC tool.
Table 1. SmartFusion FPGA registers
Offset
Name
Description
0x200
SMF_VER
SmartFusion FPGA version register
Figure 13. Get current FPGA version
4.
Upgrade the FPGA in smartFusion using the
# ./smarttool -uf /dev/ttyS0 <
path_to_the_image
>/
<
platform
>_SMF_logic_v0.E.dat
command. To upgrade to region A, you must be in region G. The device
automatically reboots after the upgrade.
72
Dell EMC DAIG-OS tools